Matching brick for older houses in CT6
Many of the older houses in Herne Bay date from the town's years as a Victorian holiday resort, and a front can have been repaired in more than one brick over its life. A patch that is right in the yard can look wrong once it is on the house, and a base with no engineering course shows as damp at the foot of the wall. This guide works through a small patch, 0.9 metres wide and 1.2 metres high, in a stock-brick front, from reading the old bond to the order.
Herne Bay Builders Merchants is the Herne Bay delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

Reading the old bond
Start with the wall itself. Find a window reveal or a corner where the bond shows, count the courses from a sill up to the lintel above, and look for headers, the short ends of the bricks, on the face. Where the pattern changes is where an old repair begins, and a patch laid to the wrong pattern will show even when its colour is right.
Look at more than one spot on the front, because a patch from an earlier repair may be the only clue to what the original bond was. Note the joint too, since a wide, rough joint and a thin, neat one read as two different walls even when the bricks match.
Measuring the courses
Work out the course height from the wall itself before any bricks are ordered. Take fifteen courses up from a fixed mark, joints included, and divide the height by fifteen. The answer tells the bricklayer whether the new work will line up with the old, and at what height the first new course should start.
Mark the fixed point on the wall in pencil before any old brick comes out, and check it again after each course is laid. A patch that drifts by a few millimetres over a metre is a common reason a repair looks wrong from the pavement.
Choosing the match
Take a sample and stand it against the wall, first dry and then wet, because brick darkens when it is soaked and a colour that looks right in the yard can look wrong on the house. Buy the whole patch in one batch, since a second delivery weeks later rarely matches the first.
On an older front a reclaimed stock brick often matches best, because it has weathered the way the wall around it has. New stock can go behind the face or into the back of the patch where no one sees it, and the best of the old brick is kept for the face.
Engineering course under the damp proof course
The two courses below the new damp proof course are solid Class B engineering brick. The height of the damp proof course is set by the designer or building control, not by the yard, so ask before the bricks are ordered.
Buy only the courses the damp needs, and keep the rest of the patch in facing brick so the face matches the house above.
Sand, cement and cuts
Measure the patch, then allow an extra tenth for cuts at the reveals and for old bricks lost in the removal. Mortar for a patch this size is five parts sand to one part cement by volume, mixed in one batch so the joints match from top to bottom.
A tonne of building sand mixes mortar for roughly a thousand bricks, so a patch of this size takes a small part of one bulk bag. Keep the rest of the bag under cover for the next job, and keep the cement off the ground until it is mixed.
Ordering for collection
An order for this patch can be collected from the yard on Lower Road in Northfleet with no delivery charge, so the bricks, the sand and the cement can be fetched in one trip. Delivery to Herne Bay is quoted for each order, and the quote depends on the address and the place the load can stand.
Ask for the pack to be stood on level ground where it is to be unloaded, and mark the house on it, because a row of similar houses is hard to tell apart from the road.
Rules of thumb
| One-brick wall | Solid wall, one brick thick: about 120 bricks to the square metre, before cuts. |
|---|---|
| Half-brick leaf | About 60 bricks to each square metre, for a leaf behind a cavity. |
| Course height | Fifteen courses, joints included, divided by fifteen. |
| Cuts at reveals | Add a tenth to a patch with reveals or an arch. |
| Mortar | Five parts sand to one part cement, by volume. A tonne of sand goes with about seven bags of cement. |
| Engineering course | Four to each 0.9 m course, so eight, plus cuts. |
The shop has calculators that turn a measurement into a quantity.
Worked order: A 0.9 by 1.2 metre patch in a stock-brick front in Herne Bay
| Product | Quantity | What it is for | Cost |
|---|---|---|---|
| Cookbridge Yellow Multi Stock Bricks | 143 at £0.65 | The patch is 0.9 m wide and 1.2 m high, so 1.08 square metres of one-brick wall. At 120 bricks a square metre that is 129.6, and a tenth for the reveals makes 142.6, rounded up to 143. | £92.95 |
| Bulk Bag Soft Building Sand Nepicar | 1 at £45.83 | The 143 bricks and the two engineering courses take about 0.15 tonnes of building sand, at a tonne for each thousand bricks. One bulk bag holds about 0.8 tonnes, so one is the order, kept under cover until it is used. | £45.83 |
| 25kg Mastercrete Cement (plastic) | 2 at £7.99 | At seven bags to a tonne of sand, 0.15 tonnes is about one bag, and two gives a margin for the joints. | £15.98 |
| Goods | £154.76 | ||
| Collected from Lower Road, Northfleet | £0.00 | ||
| Total ex VAT | £154.76 | ||
| Total inc VAT | £185.71 | ||
Bulk bags: the bags in this order are counted at about 0.8 tonnes each. That is a planning figure. The shop does not publish a weight for a bulk bag, so confirm the number of bags with the yard before ordering.
Not in this order: The lintel over any opening, the new damp proof course itself, the two solid engineering courses beneath it, the wall ties to the old wall, and the pointing or paint for the finished face.
The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.
On the shop today
The products this guide talks about, from the shop's Bricks aisle. Prices last checked .
-
Cookbridge Yellow Multi Stock Bricks
each
£0.78 inc VAT
£0.65 ex VAT
In the yard
-
Multi Clayden Red
each
£1.62 inc VAT
£1.35 ex VAT
In the yard
-
Red Class B Engineering Perf
each
£0.60 inc VAT
£0.50 ex VAT
In the yard
-
Second Hand Yellow Bricks
each
£1.44 inc VAT
£1.20 ex VAT
In the yard
Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.
Bricks delivered to CT6 See all Bricks on the shop
Delivery to Herne Bay
- CT6
-
Ask the yard about this district. It is not a shop price.
More guides for Herne Bay
- Blocks for a garden wall in CT6 Counting the footing, blocks, sand and cement for a garden wall 4.4 metres long in CT6, from the trench up, with one worked order to collect.
- Shingle for a front garden in CT6 Depth, shingle tonnage and a geotextile membrane for a gravel front garden in CT6, with a worked order to collect from the yard in Northfleet.
- A timber stud partition in a CT6 room Sole and head plates, CLS studs and boarding for a 3.0 metre stud partition in a CT6 room, counted to one worked order to collect.